Change a Farmhouse Sink Bathroom Vanity
Farmhouse sink bathroom vanity – In most cases, than the toilet and bathtub, are the only others in the bathroom a vanity sink. Since the tub and toilet are not normally replaced in most minor renovations. And you just change the vanity sink give your bathroom a new look. All this work will take a couple of hours, and very little plumbing experience is necessary.
Install the new farmhouse sink bathroom vanity, find the studs in the wall with a stud finder and mark their locations slightly higher than where the new vanity base will locate. Set Vanity position and make sure that it is flush with the wall and level. Use wood shims if necessary to help level the vanity or to make it flush against the wall. Wood screws through the vanity and the wall studs to secure the vanity in place.
Change a farmhouse sink bathroom vanity; install the faucet in the sink according to the manufacturer’s instructions. Run a bead of tub and tile seal along the top edge of the vanity and set carefully sink on top of it. Use Teflon tape to the threads of the shut-off valves. And also connect the hot and cold water supply lines to their respective valves. Then use a thin bead of tub and tile caulk around the sink edges where it meets the wall. Use your finger or a damp cloth or sponge to seal. Turn the water valve back on by turning the handle counterclockwise and then test the hot and cold water controls to function. Check all your connections for leaks.bathroom farmhouse sink,change bathroom vanity